Skip to content

Free in-person look at your old windows and doors: (817) 286-6625

Fort Worth · Haltom City · Saginaw · River Oaks

(817) 286-6625

ServicesStorm Doors

Storm Doors in Fort Worth

We install storm doors that fit the opening you actually have, including openings that are out of square, oddly sized or patched from an old installation. The right frame, closer and glass protect your entry door and let in a breeze when you want one.

Installer kneeling on a front porch, drilling the hinge side of a new white storm door on a tan brick house, with a ladder, tool bag and trim pieces nearby

Why a storm door belongs on some entries and not others

Think of it as a lighter outer door fastened to the exterior trim, standing between your entry door and the weather. Rain, blowing grit and direct sun hit it first, so the finish and weatherstripping on the main door last longer. Add a screen panel or a retractable screen and you can leave the main door open for a cross breeze while keeping bugs outside.

In older houses, the storm door tends to be the piece that went untouched for decades. We often find aluminum frames bent out of line, closers that have lost all their tension, and Z-bar rails anchored into trim gone soft under layers of caulk. With over 10 years of experience behind our team on openings like these, we check what the old door was screwed into before recommending a replacement.

A new storm door is worth it when the entry door behind it is sound but keeps getting worn down by sun and rain. If that entry door is warped, rotting along the bottom rail or letting air in around the jamb, our entry doors page explains replacing it, and both can be looked at during one visit.

What the installation includes

Measuring the real opening

We take three width readings across the brick molding opening, high, center and low, plus diagonals to see how far it is out of square. In older houses those readings can differ by a quarter inch or more. That spread tells us whether an adjustable Z-bar will close tight or whether another size is the better fit.

Removing the old door

The old storm door comes off along with its hinge rail and closer. We then seal or cover every abandoned screw hole, because open fastener holes channel water into the trim and are behind much of the rotted wood we see on older entries.

Frame, drip cap and expander

We shim the hinge-side Z-bar until it is plumb, set the drip cap so rain runs off rather than down the top rail, and adjust the bottom expander so the sweep seals against the threshold without scraping.

Closer and wind chain

The pneumatic closer is tuned so the door latches gently instead of banging. A wind chain or built-in stop keeps a strong gust from throwing the door past its hinges and kinking the frame.

Glass and screen choices

Full-view, mid-view and retractable-screen doors each fit a different kind of entry. Sun exposure, how often you open up for fresh air and how much of your entry door you want visible all guide the choice.

Final adjustment and cleanup

We run the latch, deadbolt and sweep through several cycles, then take the old door and all packaging with us.

When a storm door should be replaced

  • It won't close on its own anymore

    A tired pneumatic closer has no cushion left. The door either swings open on its own or slams, and the slamming works the hinge screws loose.

  • A bent or twisted frame

    After wind has yanked a door past its stop, the aluminum frame seldom goes back to square. It shows up as a gap by the latch or a sweep that scrapes.

  • The main door's finish is wearing out

    If the paint on your entry door is peeling or the stain has faded, the weather is hitting it head on. A storm door takes that hit instead.

  • Gaps or water stains at the edges

    Light along the hinge rail or stains on the threshold usually mean the drip cap is missing, the weatherstripping is worn, or the frame has separated from the trim.

  • Screens that rip or fall out

    Old self-storing panels with snapped clips or torn screen are often why people give up opening the door for fresh air.

How the job runs

  1. 1

    Free in-person consultation

    We visit, measure the opening, look over the trim and threshold, and note which direction the door faces. Your written quote lists the door, the hardware and any trim work separately.

  2. 2

    Ordering the right door

    We order the door in the size, color and glass style you picked. Any trim work needed to give the frame solid backing is already in the quote.

  3. 3

    Installation day

    A storm door install usually takes less than a day. We take off the old door, prep the trim, hang and shim the new frame, and set up the closer, latch and sweep.

  4. 4

    Walkthrough

    We show you how to change the closer tension between summer and winter and how to swap or roll away the screen, then leave your entry tidy.

What affects the price of a storm door

Most of the price comes from the door you pick and the condition of the opening. The written quote puts the door and any prep work on their own lines, so you can see where the total comes from. To spread the cost out, ask about $0 Down on the whole project during your consultation. 0% Financing options are offered as well.

Door style and glass
Mid-view doors with a single fixed panel sit at the low end. Full-view glass, Low-E coatings and retractable screens add to the price. Ventilating glass costs more, and it pays off on an entry facing hot afternoon sun.
How big and how square the opening is
If the opening is close to a stock size and just slightly off, an adjustable frame fits without extra work. Odd widths, which older homes often have, can call for a special size or added trim to square up the opening.
Condition of the trim
Soft brick molding, or molding cracked around old screw holes, can't anchor a new frame and has to be replaced first. We show you the damaged wood before adding that work.
Hardware upgrades
A keyed deadbolt, a heavier closer or an upgraded handle set each add to the total.

Storm door questions

Something not covered here? (817) 286-6625

Will a storm door damage my entry door in the summer heat?

It can if the door is wrong for the exposure. Full glass in front of a door that gets strong afternoon sun can trap heat and damage the finish or soften vinyl parts. On those entries we recommend ventilating glass or a screen panel so the air between the doors can escape.

My door opening is not square. Can you still fit a storm door?

Usually, yes. The adjustable Z-bar and bottom expander take up some variation, and we shim the hinge rail plumb. When the opening is too far out, we explain the options, such as trim work or a different size, before you commit.

How are your storm doors built?

We install doors with aluminum frames and tempered glass, matched to the opening. Our company is AAMA certified, and we are happy to walk through the construction of each door option during the consultation.

Can I keep my old storm door's hardware?

Rarely. Hinge rails, closers and latch sets are specific to each door model, and old closers are usually worn out. New hardware comes with the door.

Do I need a storm door if my entry door is new?

Not always. A new fiberglass or steel door under a deep porch may not need one. A storm door earns its place when the door faces the weather directly or when you want screened ventilation.

Two-story tan brick house with new black-framed windows still bearing stickers, a stepladder, toolbox, trash bags and boxes on the front lawn and walkway

Get the right storm door for your entry

We serve Fort Worth along with Benbrook, Haltom City, Saginaw and nearby towns. One visit gets your opening measured, the trim checked and a written quote in your hands.