Window Replacement in Fort Worth, Fitted to Older Houses
We replace drafty, painted-shut and fogged windows, and we install entry doors, patio doors and storm doors. Houses with some age on them come with out-of-square openings, soft sills and old repairs. We measure and inspect each opening first, so the new unit fits the house you have, from Fort Worth to Benbrook and Haltom City.
- Team with over 10 years' experience
- AAMA certified
- Free in-person consultations
- $0 down, 0% financing options

Windows and Doors We Replace
Our main work is window replacement: taking out worn single-pane, aluminum or rotted wood units and installing new energy-efficient windows sized to each opening. We also install entry doors, patio doors and storm doors, often on the same visit as the windows. Our team has over 10 years of experience with this work, and we are AAMA certified. Each service page explains what fails, how we install and what moves the cost.

Window Replacement
New windows measured to your actual openings, with rot, old sash-weight pockets and past repairs dealt with before the new unit goes in.

Entry Doors
Prehung fiberglass, steel and wood entry doors set on a flashed sill pan, with rotted thresholds and out-of-square framing corrected first.

Patio Doors
We replace worn sliders and drafty French doors with new units set on a sound, flashed sill so they glide, lock and seal properly.

Storm Doors
Storm doors measured and fitted to the actual opening, with the closer, sweep and glass chosen for how your door faces the weather.
Where We Work
We replace windows and doors throughout Fort Worth and nearby communities, including Haltom City, Saginaw, River Oaks, Sansom Park, Lake Worth and Westworth Village. We also work in North Richland Hills, Benbrook, Watauga and White Settlement. The free in-person consultation is available across all of these areas.
- Fort Worth
- Haltom City
- Saginaw
- River Oaks
- Sansom Park
- Lake Worth
- Westworth Village
- North Richland Hills
- Benbrook
- Watauga
- White Settlement
If your town is not listed but sits close to Fort Worth, give us a call and we will tell you whether we can reach you.
How a Replacement Job Runs
Every job starts with a phone call and an in-person visit. From there the steps are the same whether you replace two windows or twenty.
- 1
Phone call and visit
Start with a phone call. Describe the openings that stick, leak or fog up, and we pick a time to come out to your home. The consultation is free.
- 2
Inspection and measurements
At your home we measure each opening, check for square, probe sills and jambs, and note past repairs. We talk through insert or full-frame, frame materials and glass, and answer questions on the spot.
- 3
Written quote
You get a line-item quote covering each unit, the install method, any framing correction and cleanup. Nothing is ordered until you approve it.
- 4
Ordering and install day
Units are built to our measurements. On install day we protect floors and furniture, remove the old windows, set and shim the new ones level, insulate the gaps, then flash, trim and caulk.
- 5
Cleanup and walkthrough
We haul off the old units and debris, vacuum the work areas and walk you through operation, locks and care of the new windows and doors.
What Sets the Price of Your Project
Two houses with the same number of windows can price very differently. The size and style of each unit matter, but on older homes the condition of what surrounds the window often matters more. Here is what we look at when we write your quote.
Your quote is written line by line after we see the house in person, so you know what each opening costs and why. If spreading out payments helps, 0% Financing options are available, as is $0 Down on the whole project.
- Number and size of openings
- Each added window brings its own material and labor. Grouping several openings into one install spreads setup, travel and cleanup across all of them. Oversized or non-standard openings, common in houses from earlier decades, usually need custom-built units.
- Insert versus full-frame
- An insert window uses the existing frame and goes in faster. With a full-frame install, the old frame comes out with the sash and we work from the bare rough opening, so expect more labor plus new trim on both the interior and exterior.
- Rot and framing condition
- Soft sills, a decayed header or water damage behind the trim must be corrected before a new window can be sealed properly. We find this at the consultation, so it is in the quote instead of becoming a surprise later.
- Frame material and glass
- Vinyl, fiberglass and composite frames differ in cost and in how they handle summer heat. Low-E coatings and insulated glass cut heat gain through west and south facing windows, and the glass package you choose shows up in the price.
- Lead paint in pre-1978 houses
- Houses built before 1978 may have lead paint on sashes and trim. That changes how old units come out and how the work area is contained and cleaned, which adds time to the job.
- Doors added to the job
- An entry door, patio door or storm door has its own sizing, hardware and threshold work. Scheduling doors alongside windows means one crew setup covers both, with fewer separate trips to your home.
How We Handle a House With History
A window in a house that has stood for decades rarely matches the drawing. We plan for that before we order, not on install day.
We measure every opening, not one
Settled framing means the left and right side of the same opening can differ. We take width and height at three points and check for square, then size each window from the smallest reading so it sits plumb without forcing.
We look under the old repairs
Caulk over a split sill, a block of wood shimming a sash, layers of paint hiding rot. We probe sills and lower jambs during the consultation and show you what we found, with photos when it helps.
Insert or full-frame, explained
If the original frame is solid, an insert window can go in without disturbing interior trim. If the frame is soft or badly out of square, we explain why a full-frame install is the sounder choice and what it adds to the job.
Sealed for heat and wind
Gaps around old frames are where hot air and dust get in. We fill the space between window and rough opening with low-expansion foam, then flash and caulk the exterior so water sheds away from the sill.
Your home kept clean
We lay drop cloths at every opening, contain old glazing and paint debris, and haul away the old units. You get a walkthrough at the end so you can open, close and lock each window yourself.
Questions Homeowners Ask Us
Something not covered here? (817) 286-6625
Should I get insert windows or full-frame replacement?
It depends on the existing frame. If the frame is dry, solid and reasonably square, an insert window is a clean option that leaves your interior trim in place. If the sill is soft or the opening is badly racked, a full-frame install removes the old frame so we can fix the framing and seal the new unit correctly. We decide this opening by opening at the consultation.
My house has settled and the windows are out of square. Can new windows still fit?
Yes. We measure each opening at several points and size the new unit to fit the tightest dimension, then shim it plumb and level inside the opening. The remaining gap is filled with low-expansion foam and covered with trim. Custom-sized units handle openings that do not match standard sizes.
What happens if you find rot when the old window comes out?
We probe sills and jambs during the consultation, so most damage is found and priced before you sign. If something hidden turns up once the old unit is removed, we stop, show you, and explain what it takes to correct before going further. You decide before any added work is done.
Which frame material holds up best in Texas summers?
Vinyl is the most common choice and insulates well, but dark vinyl colors can soften and bow under long afternoon sun. Fiberglass expands and contracts at close to the same rate as glass, so its seals stay tighter through big temperature swings. Composite frames sit between the two. We look at which way each window faces and suggest a frame and glass package to match.
Do you offer financing?
Yes. Two options are available: 0% Financing options, and $0 Down on the whole project. Once your quote is written, we walk through how either one would apply to it.
My house was built before 1978. Does that matter?
It can. Paint from that era may contain lead, which means old sashes and trim have to come out with dust kept contained and the area cleaned carefully afterward. We plan for this in the quote and on install day so it does not catch anyone off guard.
Is the consultation really free, and will I be pressured to buy?
The in-person consultation is free. We measure, inspect and write up a quote, then leave it with you. If you only need a few windows now and more later, we will price it that way.

About Window Replacement Fort Worth
We are a window and door replacement company working in Fort Worth and the towns around it. Much of what we see is in older houses: original wood double-hungs with broken sash cords, aluminum sliders that sweat in winter, and doors that drag because the house has shifted on its foundation over the years.
Our focus is installation. We do not just swap a unit into a hole; we figure out why the old one failed, whether that was water, settling or a poor earlier fix, and address it so the new window or door lasts. If something we find changes the job, we tell you before work starts and put it in writing.
- In business
- Team has over 10 years of experience
- Certifications
- AAMA certified

Learn What Your Windows Need
We visit your home, measure each opening and walk you through what we see, old repairs and rot included. You leave with a written quote and no obligation.