Skip to content

Free in-person look at your old windows and doors: (817) 286-6625

Fort Worth · Haltom City · Saginaw · River Oaks

(817) 286-6625

ServicesPatio Doors

Patio Door Replacement in Fort Worth

We replace sliding and hinged patio doors in older homes, starting with what sits under the old threshold. You get a new door that rolls easily, locks tight and sheds water away from your floor, with every repair to the opening explained before work starts.

Two installers in caps and gloves lift a large white-framed sliding glass patio door into its opening on the concrete back patio of a brick house

A new patio door is only as good as the opening it sits in

Most patio doors we pull out of older houses failed for reasons outside the panel. Rollers wear flat, aluminum tracks pit and bend, and weatherstripping shrinks until you can see daylight. Underneath, there is often no sill pan, so years of rain have soaked the subfloor at the threshold.

We size the new door to the rough opening, check it for level and square, and fix soft framing before the new unit goes in. If a past owner shimmed around a sagging header or caulked over rot, we find it and tell you what it takes to correct.

Our team has over 10 years of experience setting doors into openings that have shifted with the clay soil common around Fort Worth, so we expect out-of-square frames and plan for them rather than forcing the door to fit.

What the job includes

Taking out the old door
We cut the old frame loose, lift out the panels and track, and haul all of it off. Interior trim comes off with care so any sound pieces can go back up.
Checking the opening and subfloor
Once the frame is gone, we probe the subfloor, sill plate and jack studs for soft wood. You get photos of anything we find before we add work.
Sill pan and flashing
We install a sloped pan beneath the threshold and lap flashing tape over the house wrap. Any rain that slips past the door is carried back outside rather than soaking into the framing.
Setting and insulating the frame
The frame goes in level and plumb, with shims at the hinge and lock points, and is fastened the way the manufacturer specifies. Low-expansion foam fills the gap without pushing the jambs out of line.
Hardware and adjustment
Rollers or hinges are tuned so the panel closes with light pressure. We then check that the lock throws all the way and the weatherstripping seats evenly along its length.
Trim and cleanup
Casing and exterior trim are put back or replaced, caulked and finished clean. Your floors stay covered while we work and get vacuumed before we go.

Signs your patio door is due for replacement

  • The slider drags or jumps the track

    A panel that grinds, sticks or pops off its track usually has worn-flat rollers riding on a pitted aluminum track. On many older doors, replacement rollers for that model haven't been manufactured in years.

  • Haze inside the glass

    Cloudiness you can't wipe off sits between the panes, which means the edge seal on the insulated unit has failed. Once the gas fill escapes, that glass insulates only a little better than a single pane.

  • Damage at the floor by the threshold

    Spongy subfloor, cupped hardwood or dark stains in the carpet near the sill point to water getting under the door. In older installs the usual cause is a missing sill pan.

  • Heat and drafts coming through

    Single-pane aluminum frames conduct heat straight into the room. If the glass is too hot to touch on a summer afternoon, your air conditioning is carrying that load.

  • The latch misses its strike

    If you have to lift or shove the panel before the lock will catch, the frame has likely racked out of plumb as the house settled. Setting a new door square in a corrected opening gets the lock seating fully again.

What goes into the price of a patio door

The written quote breaks the job into separate lines, covering the door itself, the trim and any framing repair. The door is only one piece of the total. On an older house, the condition of the opening can move the price as much as the model you pick.

Door type and width

A standard two-panel slider is the easiest unit to order. Hinged French doors and wide three- or four-panel units run higher. When an older opening falls between stock widths, the door has to be built to size, and that raises the price.

Frame material and glass

Low-E coatings, laminated safety glass and between-the-glass blinds each add to the total. Vinyl, fiberglass and aluminum-clad wood frames are priced differently, and the right one depends on the sun the door takes and the look of your house.

Fixing the opening

A rotted subfloor at the threshold, a decayed sill plate or a sagging header each call for more lumber and labor. We price that work only after you have seen the damage in person or in our photos.

Interior and exterior trim

Reusing interior casing that is still in good shape keeps the cost down. New casing, new exterior brick mold or paint to match the surrounding wall push it up.

How a patio door replacement runs

  1. 1

    Free in-person consultation

    We measure the rough opening, check it for square, look at the sill and talk through sliding versus hinged styles, glass and finish. You get a written quote with each line explained.

  2. 2

    Ordering the door

    Once you choose, we order the unit to the measured size. Our team is AAMA certified, and we follow the maker's installation steps so the door performs as designed.

  3. 3

    Install day

    Most single doors are out and replaced in one day. We protect the floor, remove the old unit, repair the opening if needed, then flash, set and seal the new door.

  4. 4

    Walkthrough

    Before we leave, you operate the door yourself, test the lock and see the finished trim. We show you how to keep the track clean so the rollers last.

Worker in a tool belt points out a cracked pane on a double window of a brick ranch house as the homeowner looks on; ladder, tool bag and glass panel nearby

Patio door questions we hear often

Should I choose a sliding door or French doors?

A slider never swings into the room, which makes it a good match for wide openings and tight spaces. French doors open the full width and seal more firmly at the latch, though each panel needs open floor to swing. At the consultation we see how your room and furniture are laid out and tell you which one fits.

Will a new door fit the opening I already have?

In most cases it will. Doors are sold in standard widths, and when an older opening falls between two of them, we order a door made to that size. If the framing has twisted far out of square, we straighten it first so the new door shuts, latches and seals the way it should.

What if there is rot under the threshold?

We pause the work, photograph it and walk you through it. You hear what has to be replaced and what it adds to the price before we go beyond the job you approved.

Is there a way to spread out the payments?

There is. The whole project can start at $0 down, and 0% financing options are available too. We explain the terms when we visit.

How long will my house have an open doorway?

Just the few hours between pulling the old door and fastening the new one, nearly always within the same day. We watch the forecast when booking, and we never remove a door unless we can close the opening before dark.

Two-story tan brick house with new black-framed windows still bearing stickers, a stepladder, toolbox, trash bags and boxes on the front lawn and walkway

Learn what your patio door opening calls for

We come out, take measurements, inspect the sill and framing, and go over your choices with you face to face. The written quote carries no obligation.